Repair of 1 kV branch connection in LoviSil® housing
Defective low-voltage cables are becoming more and more common and cause expensive and time-consuming repair work. Lovink Enertech offers a smart and sustainable solution for disturbed 1 kV branch connections, without a replacement cable, large weld hole or extra cable joints.
Damage caused by excavation work
In the Netherlands, Netbeheer Nederland registered more than 6,000 cable damages in 2018, 90% of which were in low-voltage cables. The result? Households are without power, internet and television. Fast recovery is crucial to limit nuisance.
Traditional Autumn Method
In the event of a defective branch connection, a large piece of cable is often cut from the route, new cable is laid and connected to three cable joints. This approach requires a large weld hole, extra cable and high costs.
Sustainable and cost-effective solution from Lovink
Is the interference limited to the branch joint and are the wires intact? Then Lovink offers an efficient solution:
- The branch joint is removed and the wires are reconnected.
- The connection is provided with a Lovink KB outer shell filled with Protolin® resin.
This resin adheres perfectly to the ABS shells and guarantees a watertight seal and optimal protection.
Advantages of this method
- No additional cable sleeves required
- Smaller weld hole, less digging
- Faster assembly, crucial in the event of malfunctions with many households
- Lower costs and satisfied customers
Faulty connection
Renewed connection
