LoviSil® cross-bonding splices make cable network reliable

Lovink Enertech recently solved a significant problem at an energy company in Germany. The company had been struggling with an unusually high number of malfunctions and high measured settlement flows for some time. The LoviSil® cross-bonding splice not only offered a reliable solution but also saved a lot of costs.

Challenge: Failures and Ohmic Losses

In the underground route there are 3 x 1-core connecting splices and above ground the routes/pipes of the railway network cross. For a while, replacements took place after failures with cold shrink splices. These were possibly caused by the thermal stress on the cable due to the high equalization currents. The company went in search of a splice that could control the ohmic losses and guarantee an uninterrupted electricity supply.

Advantages of LoviSil® cross-bonding splice

Lovink Enertech offered a suitable solution with the LoviSil® cross-bonding splice. One of the wishes was to replace the old MV joints one on one, without the use of extra connections. This could also be achieved through the LoviSil® technology. The current joints have been dismantled and the cable has been separated exactly at the connector, after which the new connector has been mounted. The cross-flush construction is built by connecting the earth screens of the 1-core cables crosswise with each other.

New concept tested

Lovink Enertech trained the technicians for this LoviSil® cross-bonding technology and supported the initial installations. Dozens of splices have now been replaced and the first measurements show minimal losses. In short, the energy company is very satisfied with the use of the LoviSil® cross-bonding splice and is introducing a new concept for load distribution in the cable network.